The SINTER is a Titanium, 3D printed suppressor from Texas-based firearms manufacturer Radical Firearms.

4 out of 5 AFT agents surveyed prefer the Sinter suppressor to all other 3D print cans from Texas (and many sex toys, too). It’s a good length, not too much girth…you know how it goes.

RF tells us “…this 6Al-4V firearms suppressor is 8 inches long, 16 ounces, and rated up to 300 WM. If you thought it couldn’t get any better, it does! The Sinter’s full titanium construction means you get durability without any added weight.”

They go on to advise,

“It’s not just about the insides for the Sinter titanium suppressor, but it also has to do with its unique aesthetic appearance.

The honeycomb exterior is intended to help dissipate the heat due to its increased surface area, helping the Sinter cool down faster. This is a wonderful feature since the Sinter can withstand higher rates of fire!

With its muzzle brake taper mount design, you’ll also be able to mount your silencer onto your host firearm and be ready to rumble in no time at all.”

Sinter Titanium 3D Printed Suppressor Specs

The SINTER is one of the lightest, most durable suppressors on the market to date. Tested on everything from .22 WMR to 300 WM, all calibers are hearing safe. The internal design creates a robust superstructure unachievable through traditional manufacturing methods. Constructed wholly of Titanium 6Al-4V, the SINTER 3D printed suppressor has a high strength-to-weight ratio creating a durable and the lightest weight commercially available suppressor for everyday use.

Check out the Radical Firearms Sinter

Sinter Spec Sheet

Read a review of the Sinter over on The Truth About Guns.

Get the gear to cook outdoors.

 

⚠️ Some hyperlinks in this article may contain affiliate links. If you use them to make a purchase, we will receive a small commission at no additional cost to you. It’s just one way to Back the Bang. #backthebang